Choose a rubber grommet in four steps: measure the hole, match the groove to the panel thickness (with a steel gauge chart), size the ID and check flange clearance.
Rubber Feet Warehouse |
Measure the inside diameter and cross-section, read the AS568 dash number, choose a compound for the fluid and temperature, then install without twisting. A practical guide to buying the right...
Rubber Feet Warehouse |
Rubber washers are sized OD x ID x thickness. Match the ID to your bolt, then choose the OD and thickness for sealing, cushioning or spacing. Bolt-to-washer table and a...
Rubber Feet Warehouse |
Measure the outside diameter of the cane, crutch or walker tube and buy the rubber tip with the same inside diameter. Size chart from 3/8" to 1-1/4", fitting steps and...
Rubber Feet Warehouse |
Measure the hole or the pipe's inside diameter, then pick the style: push-in plugs for sheet-metal holes, tapered line-sealing plugs for pipes and drains, blank grommets for larger panel holes....
Rubber Feet Warehouse |
Your panel hole diameter equals the grommet's groove diameter — that one rule answers most sizing questions. Here's the 30-second method plus the two other dimensions that matter.
Rubber Feet Warehouse |
Ordering the wrong grommet usually comes down to measuring the wrong dimension. Here are the four measurements that matter, in the order to take them.
Rubber Feet Warehouse |