Rubber Feet for Speakers and Subwoofers (1-1/2" x 1-1/2")
Why speakers and subwoofers benefit from rubber feet, how they compare with spikes and pads, and how to fit a 1-1/2" x 1-1/2" screw-on foot to a cabinet.
Rubber Feet Warehouse |
News
Rubber Feet for Speakers and Subwoofers (1-1/2" x 1-1/2")
-
Cane, Crutch and Walker Tip Sizes: How to Measure for a Replacement Rubber Tip
Measure the outside diameter of the cane, crutch or walker tube and buy the rubber tip with the same inside diameter. Size chart from 3/8" to 1-1/4", fitting steps and...
Rubber Feet Warehouse |
-
Rubber Plugs for Holes and Pipes: How to Pick the Right Type and Size
Measure the hole or the pipe's inside diameter, then pick the style: push-in plugs for sheet-metal holes, tapered line-sealing plugs for pipes and drains, blank grommets for larger panel holes....
Rubber Feet Warehouse |
-
How to Stop Appliances and Equipment From Vibrating, Walking, and Scratching Floors
The fix for buzzing mini fridges, walking sewing machines, rumbling subwoofers, and treadmills that creep: solid rubber feet with embedded washers, matched by machine.
Rubberfeetwarehouse |
-
What Size Screw Do I Need for Rubber Feet? (Complete Chart)
Match the right screw to every rubber bumper foot size - #6, #10, and #12 screw chart by foot diameter and height, with links to feet that include the screws.
Rubberfeetwarehouse |
-
Big Blue Water Filter Housing Leaking? Replace the O-Ring ($2 Fix, 15 Minutes)
A leaking Big Blue filter housing is almost always a $2 O-ring that flattened with age. The 15-minute replacement procedure, the silicone-grease-only rule, and the two mistakes that cause repeat...
Rubber Feet Warehouse |
-
EPDM vs Neoprene: Which Rubber for Outdoor Use?
Both are outdoor-capable rubbers, but they win different environments: EPDM dominates in direct sun and ozone, neoprene wins where abrasion and occasional oil enter the picture. The decision rule is...
Rubber Feet Warehouse |
-
How to Fix a Slamming Door (Cabinet, Interior, Sliding & Screen Doors)
Every slamming door is an energy problem: the door arrives at the frame too fast with nothing to absorb the impact. Here's the fix for each door type, from cabinet...
Rubber Feet Warehouse |
-
How to Protect Hardwood Floors from Furniture (Why Felt Pads Fail)
Felt pads fall off, absorb grit, and sand your floors. Rubber caps, screw-on feet, and load-spreading pads attach mechanically and protect hardwood for years — here's which to use where.
Rubber Feet Warehouse |
-
How to Make an Air Compressor Quieter (The $20 Rubber Fix First)
Most of a compressor's noise is vibration transmitted through the floor and walls — and about $20 of rubber mounts, pads, and grommets cuts it dramatically. Here's the order.
Rubber Feet Warehouse |
-
How to Fix a Wobbly Table or Workbench (4 Real Fixes, Not Folded Napkins)
A wobbly table has exactly two causes — uneven legs or an uneven floor — and both have permanent hardware fixes that cost a few dollars. Here's how to diagnose...
Rubber Feet Warehouse |
-
What Size Rubber Grommet Do I Need? (Answer in 30 Seconds)
Your panel hole diameter equals the grommet's groove diameter — that one rule answers most sizing questions. Here's the 30-second method plus the two other dimensions that matter.
Rubber Feet Warehouse |
-
How to Stop a Dryer from Shaking and Making Noise (Fix It in Order)
A shaking dryer is usually a leveling problem, a load problem, or hard feet on a hard floor — here's the diagnostic order that fixes most dryers in one afternoon.
Rubber Feet Warehouse |
-
How to Stop a Washing Machine from Shaking and Walking (5 Fixes in Order)
Most shaking, walking washing machines are fixed by leveling the legs and putting solid rubber anti-vibration pads under the feet — here's the full checklist in order, including the one...
Rubber Feet Warehouse |
